As a part of our quality and customers' satisfaction policy, we are improving LITIO permanently through research and development. After a lot of experimentation, we have launched new version 1.3, which contains the following 3 new patterns:

Offset Cone - Unparallel

This pattern is like # 2 [Offset cone], but this option allows you to draw a round-to-round transitions with an offset and with an inclination angle between the upper end and the lower one.

Rectangle to Round - Offset - Unparallel

This pattern is like #5 [Rectangle to round - Offset], but both ends are not parallel. And it is also similar to the previous one, but one of the ends is a rectangle, either with straight or fillet (rounded) corners. Remember, that such a rectangle can also be an oblong (e.g., X=2R or Y=2R).

Round to Round Bifurcation - Non symmetrical

Finally, this pattern is like #3 [Round to round - Bifurcation], with the following differences: the three ends have a different diameter, and the bifurcating ends have a different height.

Download DEMO of this new version [615 KB].